Publicidad
Idiomas disponibles
Idiomas disponibles
Bonaire Window Cooler
Installation
Before Startup
Check that another door or window in the room is open to allow air to exhaust to other parts of the
house.
Turn the water supply to the cooler on. Wait untill water tank is full and float valve close the water
incoming.
Plug the cooler into a 110V 60Hz single phase grounded appliance socket on the inside of the house
and switch the socket on.
Press the COOL button to on the water pump.
Press the Speeds buttons and check the operation of the three speeds motor.
Leaving the unit in the COOL mode for 15 minutes, you may notice a wet paper smell as the water
circulates around the filter pads. This is normal during the commissioning phase and at the beginning
of each season when the unit is operated after the winter break. It will only last for a short time.
Drain completely water tank removing drain plug and refill again the water tank.
13
Page
Publicidad
