Descargar Imprimir esta página

Preparation; Menu 1: Start Function For The Hand Transmitter - Novoferm N-423 Accu Manual De Instrucciones

Ocultar thumbs Ver también para N-423 Accu:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

• To quit the menu, press button (D) repeatedly until "0" is displayed again or
until the display goes out.
• Outside the menu, button (B) can be used to generate a start pulse.
Information on further and/or special settings can be found in the chapter "Special
settings".

4.10.1 Preparation

1. Make sure that the garage door is securely engaged in the carriage.
2. Make sure that the antenna is correctly positioned (see section "Routing the
antenna").
3. Make sure that you have all hand transmitters for this garage door at hand.
4. Make sure that the accumulator pack is charged.
5. Open the cover at the drive head.
6. Mount the cable between drive head and accumulator pack.
ð The point display lights up.
4.10.2 Menu 1: Start function for the hand transmitter
D
A1
Fig. 8: Programming the start function for the hand transmitter
1. Briefly press the programming button (PROG button) (D).
ð The display shows "1".
2. When the display flashes, press the hand transmitter button with which you
will later start the drive until the point display (A1) on the display flashes
4 times.
3. As soon as the light goes out, you can set the next hand transmitter (see
Step 1).
NOTICE
Up to 10 codes can be learned.
(Example: 5x start and 5x light).
EN - 59

Publicidad

loading