Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION OF THE WIRELESS PIR
Do not mount the sensor near windows, air conditioning, heating sources, fridge, and oven.
Do not expose to direct sunlight and avoid areas where temperature may undergo sudden
changes. Open the case and remove the PIR strip to activate the batteries. Fix the wall
bracket with the supplied screws and hook the detector. It should be installed at a height of
2.2 meters above the ground. Adjust the support to change detection distance and angle.
The detector is more sensitive to transverse and vertical movements. If two detectors are
installed in the same room, adjust the position in order to avoid interference and false alarms.
Test
A
B
Top view
• After one minute self-test, press the test button on the back. Move to the detection field and
watch the LED to make sure that the detector is working.
• The LED indicator flashes once when body motion is detected.
• Adjust the detector angle according to your needs.
This motion detector has smart power saving function. If the detector is triggered
twice within 3 minutes , it enters sleeping state immediately to save power .
During this period , any movement detected does not generate an alarm . After
no movement within the next 3 minutes , it goes back to working state again.
Note: if the detector goes into sleeping state , it is suggested to leave the room
and make sure nobody moves in the detection area . The detector will go back
to working state in 3 minutes
WIRELESS DOOR/WINDOW INSTALLATION
Avoid mounting the sensor in areas with large quantities of metal or electrical cables, for
example, an oven. Open the case and remove the strip to activate the battery. Mount the
sensor on the door or window and the magnet on the frame. Make sure that the magnet is
placed on the side of the transmitter (indicated by the arrow). Mount the magnet at a max.
distance of 1 cm from the transmitter.
8
GB
C
2.2 from
ground
Side view
High
Publicidad
