BE Power Equipment B4014VTBA Manual Del Operador página 31

TROUBLESHOOTING
Pressure
Fluctuation
Thermal Valve
Leaking.
Water in Oil.
(pump oil is a
milky color)
ELECTRIC MOTOR TROUBLE SHOOTING
Motor doesn't
start.
(makes no
noise)
(doesn't trip any
breakers)
Motor overheats
Motor doesn't
start.
(Trips wall
breakers)
(Trips reset on
motor)
(Motor only
hums)
www.bepowerequipment.com
Clogged Check Valve.
Gun failure.
Worn valves and/or seals
in head of pump.
Unit was over heated.
Unit overheated and
thermal shocked.
Unit is not switched on.
No power going to unit.
Breaker needs to be
reset (wall and/or unit).
Faulty on/off switch.
Extension cord being
used.
Unloader adjusted too
tight.
Clogged spray nozzle.
Too much pressure in the
brass head.
Extension cord being
used.
Unloader adjusted too
tight.
Breaker rating doesn't
match the pressure
washer.
Weak circuit breaker.
Wall plug in too far from
main electric panel.
Need to clean or replaces
valves. Recommend call service
center.
Trigger flaw, intermittedly
siezed. May need to clean or
replace.
Need to replaces seals.
Recommend call service center.
Need to replace thermal valve.
Call service center, may need to
replace pump.
Turn switch to the ON postion.
Check the cord for faults, make
sure it is plugged into correct
outlet.
Reset Breakers.
Replace switch.
Plug directly into wall, or use
much heavier guage of cord.
Adjust or replace unloader.
Clean or replace nozzle.
Relieve pressure by pressing
the trigger on the gun. Keep
trigger held down while starting
the machine.
Plug directly into wall, or use
much heavier gauge of cord.
Back off unloader.
For example, if pressure washer
is 17amp draw, it needs at least
a 20amp breakers.
Try machine on several different
outlets.
Try machine on an outlet closer
to the panel.
31