Maintenance; General Maintenance - Hart HPSP25 Manual Del Operador

MAINTENANCE

WARNING:
If product is not working as it should, has been dropped,
damaged, left outdoors, or dropped into water, take it
to a service center prior to continuing use.
WARNING:
Have servicing performed by a qualified repair person
using only identical replacement parts. This will ensure
that the safety of the product is maintained.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
WARNING:
The motor is equipped with bearings which contain
sufficient lubrication for its lifetime. The addition of
lubrication could cause damage. Do not add lubricant
to motor.
CLEANING AND STORING THE SPOT
CLEANER
See Figures 13 - 15, page 10.
WARNING:
Never allow the amount of waste liquid to exceed the
max fill line. Failure to follow this rule may allow liquid to
enter inside the unit which could cause shock, property
damage, or personal injury.
 Remove the battery pack.
 Place the unit on a level surface.
CAUTION:
If the recovery tank contains liquid, do not turn the unit
upside down as it may enter the motor.
NOTE: ILLUSTRATIONS START ON PAGE 11
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
To clean the recovery tank:
 Depress the tank release lever above the recovery tank.
NOTE: The recovery tank is on the right side of the
appliance.
 Lift the tank up and away from the spot cleaner.
 Unlock the latch on the back of the tank and remove the
lid.
 Separate the upper and lower halves of the tank.
 Empty the recovery tank.
 Place the lid back on the recovery tank and secure using
the latch.
 Lower the bottom of the recovery tank onto the spot
cleaner at an angle and then push the top of the tank
toward the spot cleaner until the release lever clicks into
place.
To clean the solution tank:
 Remove the solution tank as described earlier in the
manual.
 Unscrew the measuring cap and empty any excess
formula, then add warm water to the "self clean fill line".
 Replace the measuring cap and reattach the solution
tank.
To clean the hose:
 Remove the hose and pet tool from the storage clips.
 Depress the tab on the pet tool and remove it from the
hose.
 Attach the hose rinse tool stored on the back of the unit
to the end of the hose.
 Insert the battery pack.
 Press the ON/OFF button to start the spot cleaner.
 Press the switch trigger for 30 seconds.
NOTE: The clean water will rush through the hose,
effectively cleaning and any leftover dirt & debris from
the hose.
 Press the on/off button to stop the spot cleaner.
 Repeat as needed until the hose is cleaned.
 Remove the battery pack.
 Remove and empty the recovery tank.
 Clean recovery tank, pet tool, and brush insert.
NOTE: Warm water and mild soap can be used to clean.
 Make sure all parts are dry before reassembly.
 Store indoors in a place that is inaccessible to children.
Keep away from corrosive agents.
8 – English