Publicidad
Idiomas disponibles
Idiomas disponibles
PART 4 - INSTALLATION
4.1 - Positioning of the machine
Fill the water tank. Make sure you put in
more than the minimum amount re-
quired for machine operation (75 mm
from the top of the tank) but do not ex-
ceed the maximum level (20 mm from
the top of the tank).
Connect the Roner to the immersion
tank by means of the connector behind
the machine.
Make sure the liquid does not enter the
machine.
4.2 - Connection to the mains
The machine has a power cable (3x1.5 mm² x 2.5 m) and a 16A Shuko plug. Connect
the 230 V 50 Hz machine by installing a 10A I = 0.03A residual-current device on the
line. Also check that the information on the machine's nameplate match the specifica-
tions given in the delivery and shipping documents, and that both the master switch
and cable are easily accessible while the machine is in use.
4.3 - Wiring diagram
SWITCH
FLOAT
NTC1
POWER BOARD
ELEMENT
10
Fig. n°5
NTC2
SAFETY
KEYBOARD
BOARD
Fig. n°6
Publicidad
