Publicidad
Idiomas disponibles
Idiomas disponibles
5.3. SETTING THE TIME & DATES
The time and day must be set when you first switch the product on, or when
the product is disconnected and reconnected from the power supply.
It's also possible to configure this by pressing the
onds when the product is in STAND-BY. The display will show the word "SET"
and then suggests changing the TIME and DAY of the week.
The time is set by holding down the
hour and minute value is reached.
Click the
MODE button to confirm the clock setting and continue to the
day setting.
The display will show the word "DAT" and then suggests the day of the week.
D1 corresponds to Monday, D2 to Tuesday and so on.
Use the
INCREASE button to set the current day of the week, e.g. if it's
Thursday press the
Press the
MODE button to confirm the day and exit the setting.Once the
time has been set, it will stop flashing.
If you product is in STAND-BY mode and you wish to turn it on, press the but-
ton for 2 seconds.
5.4. MANUAL MODES
There are 4 Manual operating modes: Pilot Wire, Comfort, Night and Anti-Frost.
PILOT WIRE mode (only available on request)
The Pilot Wire is a special communication protocol that allows an external
unit or control unit to control the radiator. It's shown on the display by an
arrow pointing to the house symbol.
To activate Pilot Wire mode, press the
will appear briefly along with an acoustic signal.
IMPORTANT: This function is not available unless requested, even if it is
displayed on the menu.
PALAOS VERTICAL DIGITAL RADIATOR
INCREASE button until the current
button 4 times until you reach D4.
MODE key once. The message "FP"
MODE button for 5 sec-
EN
17
Publicidad
