Teaching-In - HomeMatic IP HmIP-WUA Manual De Instalacion Y Uso

The phase conductor connection is marked with an arrow pointing
to the centre of the device, the switched phase conductor with an
arrow pointing towards the outside. To connect or loosen the con-
ductor, press the white actuation lever at the top of the clamp.
The network terminals may be used only for connecting the power
supply to the device or for connecting loads to the device. The con-
nection (looping through) of conductors via the network terminals
of the device to other devices is not permitted!
• Close the cover caps of the universal actuator again (see fig. 10).
• Turn the main fuse back on (see fig. 11), to activate the device's
teach-in mode (see „5.3 Teaching-in" on page 35).
5.3

Teaching-in

Please read this entire section before starting the teach-in procedu-
re.
First set up your Homematic IP Access Point via the Homematic IP
app to enable operation of other Homematic IP devices within your
system.
For further information, please refer to the operating manual of the
Access Point.
You can connect the device either to the Access Point or to the
Homematic Central Control Unit CCU3. For detailed information,
please refer to the Homematic IP User Guide, available for download
in the download area of www.homematic-ip.com.
To integrate the device into your system and to enable control via the free
Homematic IP app, you must first teach-in the device to your Homemat-
ic IP Access Point.
To teach-in the device, please proceed as follows:
• Open the Homematic IP app on your smartphone.
Operation
35