Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS, MONTAGE AND SETTING OF THE SENSOR
Make sure that the wind sensor is mounted horizontally to the earth,
otherwise the measurement result will be influenced!
Mounting types
Mounting on
Programming the sun/wind sensor
1.
Set the radio receiver or radio motor on which the sensor is to be taught-in to teach-in mode according to the associated
instructions.
Make sure that no other receiver is in „learning mode".
2.
Press the learn button on the sun / wind sensor within 10 seconds.
Successful teach-in is acknowledged by a short vibration of the motor connected to the radio receiver or the vibration of
the radio motor.
3.
The sun / wind sensor must then be activated with a hand-held transmitter that has already been taught-in
(see page 19).
The motor (the sunshade) can now be controlled automatically via the sun / wind sensor functions.
The TDSW-01 can also be used to control several motors / receivers (sunshade systems) simultaneously.
It is important to note that the wind and sun conditions on the controlled equipment (awnings, blinds) are equivalent.
To teach-in additional motors / receivers, proceed as described.
Set the receiver (radio
motor) to teach-in
mode according to the
associated instruc-
tions.
18
Wall mounting
Press the learn but-
ton on the sun / wind
sensor.
Motor vibrates briefly.
90˚
Ceiling mounting
Activating the sun / wind
(engine vibrates)
sensor see page 20.
Publicidad
