Descargar Imprimir esta página

Light Intensity - JAROLIFT TDSW-01 Instrucciones Originales De Instalación Y Funcionamiento

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 32
Adjusting the wind control
ATTENTION!
The values given are approximate! In addition, gusts can increase the wind load extremely for a short time. It should also be noted that
the closing of the awning, depending on the projection, takes some time and the awning is unprotected during this time.
Therefore, in case of doubt, always set the lowest wind value!
1.
Press the "Wind intensity" key and hold it down for approx. 2 seconds.
The "Wind" display starts to flash.
2.
Briefly press the "Wind intensity" key several times until the appropriate (desired) threshold value is shown in the dis
play.
Adjustable values: 0 - 5.
Refer to the table below for the values and corresponding wind speeds.
3.
Confirm the selected threshold with the sun intensity key.
The indicators on the display stop flashing.
Value:
Wind speed
ATTENTION! wind sensor
0
deactivated
1
ca. 10 km/h
2
ca. 15 km/h
3
ca. 20 km/h
4
ca. 30 km/h
5
ca. 40 km/h
Setting the sun control
1.
Press the "Sun intensity" key and hold it down for approx. 2 seconds.
The "Sun" display starts to flash.
2.
Briefly press the "Sun intensity" key several times until the appropriate (desired) threshold value is shown in the display.
Adjustable values: 0 - 9.
Refer to the table below for the values and corresponding light intensity (lux).
3.
Confirm the selected threshold value with the wind intensity key.
The indicators on the display stop flashing.
Value:

Light intensity:

Sun sensor
0
deactivated
1
2.000 Lux
2
5.000 Lux
3
10.000 Lux
4
20.000 Lux
5
40.000 Lux
6
60.000 Lux
7
70.000 Lux
8
80.000 Lux
9
90.000 Lux
Example:
With a set threshold value of 1, the awning (blind) retracts automatically when the
wind speed exceeds approx. 10 km/h.
ATTENTION!
It is imperative that you observe the permissible wind load for your sun sha-
ding system! Setting the wind speed too high is not permissible and can lead to
considerable damage to the controlled sun shading system as well as to danger
to persons!
Example:
With a set threshold of 4, the awning (blind) will automatically extend when
20,000 lux is exceeded.
If the value subsequently falls below 4 for longer than approx. 10 minutes, the
awning (blind) automatically retracts again.
Note:
To be able to operate the awning manually despite twilight or darkness, the
sun control must first be deactivated.
To do this, set the threshold value of the sun control to the value "0".
ADJUSTING THE SENSOR
19

Publicidad

loading