Publicidad
Maintenance
Change of the cut-off disc
Once the cut-off disc wears out, they should be replaced
immediately.
WARNING
The cut-off disc specified for this tool
are 6-1/2". Do not use any other size. Failure to do so
may result in an accident or damage to the tool and void
your warranty.
• Do not use damaged or oversized washers and bolts.
The included bolts and washers are specially designed to
ensure proper operation and safety when using the tool.
• Use cut-off discs with holes of the correct size and shape
for the shaft. Otherwise, they may rotate in an eccentric
motion causing loss of control.
1. Remove the battery from the tool and set the cutting
depth to minimum, do not use abrasive discs (see page
10).
2. Fully open the retractable guard (F) and hold it in that
position.
3. Place the wrench (G) on the hex bolt (H) and press
and hold the spindle lock knob ( I ). Turn the bolt
counterclockwise. The cutting disc will rotate at the same
time as the bolt, until the shaft is fully locked when the
locking knob is fully engaged.
4. Loosen and remove the bolt, remove the outer washer
(J), disc and inner washer (JI). Release the shaft locking
knob.
5. Place the inner washer (JI) and the new cut-off disc
(K). Make sure that the direction of the arrow printed on
the disc matches that of the arrow engraved on the tool
guard.
6. Place the washer (J) on the disc and insert the
hexagonal screw (H).
7. Press the shaft lock button again. Tighten the hex bolt
with the wrench (G) clockwise. Once the disc is secured,
release the spindle lock button.
General maintenance
•Cleaning, maintenance; method to keep tools sharp and
regular lubrication.
• Remember to remove the batteries from the tool before
cleaning or servicing.
• All tool components are an important part of the
insulation system and should only be serviced by a
Authorized Service Center.
• When servicing the tool, ALWAYS ask for
original spare parts.
• When cleaning plastic parts, avoid using solvents. Most
plastic materials are susceptible to damage from various
types of commercial solvents.
• To clean dirt, carbon or dust use a clean cloth or
pressurized air.
WARNING
NEVER bring the tool into contact with
brake oil, petroleum-based products, penetrating oils, etc.
H
J
JI
Only clean, sharp and properly installed discs
can guarantee a good cut. Keep extra cutting
discs on hand so that sharp discs are always
available.
They contain chemicals that can damage or destroy the
plastic.
• When using pressurized air to clean
WARNING
particles ALWAYS wear safety glasses with side shields or
face shield, in case of high dust ejection, also wear a dust
mask.
It is not recommended to use this tool for extensive work
on fiberglass, plasterboard, drywall or plaster materials,
since its particles are highly abrasive to the components
of any power tool. In case of using the tool in any of these
materials it is very important that it is frequently cleaned
with pressurized air to increase the useful life of the tool.
I
G
K
ENGLISH
F
11
Publicidad
