Steinberg Systems SBS-BT-918 Manual De Instrucciones página 32

1. Start the engine in the vehicle.
2. Connect the terminals to the poles: red to positive and black to negative.
3. Use the arrows to select item number 3 in the "MAX WORK LOAD" main menu.
4. A message will appear on the display:
5. Increase the engine speed to 2000-2500 rpm, then press the "ENTER" button.
6. The display will indicate the test results, such as:
- "VOLT" - current value
- "MIN: (minimum value) V < (standard value) V"
If the minimum value is higher than the standard value, the system is working
properly. Otherwise, check whether the drive belt is damaged or a short circuit has
occurred.
7. Press the "ESC" key to return to the main menu.
8. Turn off the engine and remove the terminals (first the negative, then the
positive).