Cleaning And Maintenance - Steinberg Systems SBS-BT-918 Manual De Instrucciones

• "MAX: (maximum value tested) < (maximum measurement value)"
- "VOLT" - current value
- "MIN: (minimum tested value) < (minimum measurement value)"
If the value is higher than the maximum measurement value, check that the
voltage regulator is not defective.
If the value is lower than the minimum measurement value, check the terminal
connection or check the motor condition.
7. Press the "ESC" key to return to the main menu.
8. Turn off the engine and remove the terminals (first the negative, then the
positive).

3.4. Cleaning and maintenance

a) Disconnect the terminals before any cleaning or adjustment.
b) After each cleaning, all the parts should be dried well before the unit is used
again.
c) Store the unit in a dry and cool place protected from moisture and direct
sunlight.
d) Do not spray the unit with a stream of water or immerse it in water.
e) Perform regular inspections of the unit checking technical fitness and any
damages.
f) Use a soft cloth for cleaning.
g) Do not use sharp and/or metal objects (e.g. a wire brush or metal spatula) for
cleaning, as these may damage the surface of the material from which the unit
is made.
h) Do not clean the unit with acidic substances, medical products, diluent, fuel,
oil or other chemicals as this may cause damage to the unit.
DISPOSAL OF USED UNITS.
At the end of its useful life, this product should not be disposed of with normal
household waste but should be taken to a collection point for the recycling of
electrical and electronic equipment. This is indicated by the symbol on the
product, operating instructions or packaging. The materials used in this unit are
recyclable according to their marking. You will be making an important
contribution to protecting our environment by reusing, recycling or otherwise
disposing of used units.