Extremis STICKS Manual Del Usuario página 7

FLOOR FASTENING
1. Begin by marking the centre of
the base and drill a ø6 mm hole
through the base.
4. Position the base making sure
that the hole in the middle of the
base is situated exactly above the
hole. Insert a screw (ø6mm, L:
80mm) in this hole and tighten it
as much as possible.
2. Position the base where you want
to install your Sticks. Insert a pen
in the hole in the middle of the
base and mark the floor.
5. Insert the rods in the base.
TIP
: If possible, cover the screw
with a black cap.
3. Drill a hole at the marked spot.
Insert a plug n° 8 in the hole.
6. When all the rods are in place,
the cap is not visible.
english 7