Emos E0316 Manual Del Usuario página 6

the weather station or sensor. Only use 1.5V alkaline batteries of the same type; do not use
rechargeable 1.2V batteries. The lower voltage may cause both of the units to not function.
2. Place the two units next to each other. The weather station will detect the remote sensor signal
within 3 minutes. If signal from the sensor is not detected, long-press the CH button on the
weather station to repeat the search.
3. If the outdoor temperature reading disappears from the screen, long-press the CH button on the
station and press the TEST button on the sensor. The weather station will reset all the values
and repeat the search for sensor signal.
4. We recommend placing the sensor on the north side of the house. The range of the sensor may
decrease substantially in areas with a large number of obstacles.
5. The sensor is resistant to dripping water, however, it should not be permanently exposed to rain.
6. Do not place the sensor onto metal objects; doing so will reduce the transmission range.
7. If the low battery icon is displayed, replace batteries in the sensor or weather station.
Switching Channels and Connecting Additional Sensors
1. Repeatedly press the CH button on the station to select the sensor channel of choice – 1, 2 or 3.
Then, long-press the CH button. The
2. Remove the battery cover on the back of the sensor and move the channel number switch to
the channel number of choice (1, 2, 3).
3. Insert batteries into the sensor (2× 1.5 V AAA); the channel number will be displayed on the
sensor's screen.
4. Data from the sensor will be loaded within 3 minutes.
5. If sensor signal is not detected, repeat the process.
Displaying Data from Multiple Sensors, Automatic Cycling through Values from
Connected Sensors
Press the CH button repeatedly to display data from all connected sensors one by one. You can also
activate automatic cycling through data from all connected sensors:
1. Turning on cycling
Repeatedly press the CH button until
Data from all connected sensors will be shown automatically and repeatedly one after another.
2. Turning off cycling
Repeatedly press the CH button until the
Radio-Controlled Clock (DCF77)
After being registered by the wireless sensor, the weather station will automatically start searching
for DCF77 (DCF for short) signal for 7 minutes; the
mation on the screen will be updated and the buttons will be disabled (except SNOOZE/LIGHT). Once
the signal is detected, the icon will stop flashing (
displayed. If no signal is detected, the DCF icon will not be displayed.
To repeat the search for DCF signal, long-press the WAVE button. To cancel the search for DCF signal,
short-press the WAVE button. DCF signal will be synchronised daily between 2:00 and 3:00 am.
During daylight saving time,
Note: If the weather station detects DCF signal but the current time on the screen is incorrect (e.g.
shifted ±1 hour), you must set the correct time zone for the country where you are using the station,
see Manual Settings.
In standard conditions (at safe distance from sources of interference, such as TV sets or computer
monitors), the reception of time signal takes several minutes. If the weather station does not detect
the signal, follow these steps:
1. Move the weather station to another location and try to detect the DCF signal again.
2. Check the distance of the clock from sources of interference (computer monitors or television
sets). The distance should be at least 1.5 to 2 m during the reception of signal.
icon will begin flashing.
. appears on the screen.
. icon disappears.
icon flashes. During the search, no other infor-
stays on the screen) and current time will be
will be displayed on the screen.
6