Truper MOTO-AI Manual De Instrucciones página 9

Start Up
Disc holder shaft
• The disc holder is used with serrated cutting discs,
abrasive discs and polishing discs.
1. Fit the disc holder (A) into the rotary tool as you do the
other accessories. (See page 8).
2. Using the screw (B), secure the disc you need, firmly
tightened with the screwdriver tip in the accessory
adjusting wrench (C). While tightening the disc, keep the
shaft lock depressed (D).
CAUTION
• Use care not
tightening the discs in excess. They
might break.
C
Sandpaper ring shaft
1. Insert the sanderpaper ring (A) in the grain sander (B)
more suitable for the job.
2. Install the stud in the Moto - Tool as you do for the
other accessories. (See page 8).
3. Tighten the stud screw (C) ) to secure the sander. Keep
the shaft locked (D) pressed while tightening the screw.
B
2
B
1
D
A
1
A
3
D
C
9
ENGLISH