Descargar Imprimir esta página

Assembly Preparation - Pit Boss PBV3D1 Montaje Y Operación

Publicidad

Idiomas disponibles

Idiomas disponibles

Parts are located throughout the shipping carton, including underneath the smoker. Inspect the unit, parts, and hardware blister
pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the griddle
before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt
to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss® Grills Customer Care for parts.
service@pitboss-grills.com | USA: (480) 923-9630 | CANADA (TOLL FREE): 1-877-942-2246
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
Tools required for assembly: screwdriver and level. Tools not included.
-
It is advised to review each step entirely before starting assembly on instructions.
Hardware combination involving a locking washer and washer should be installed with the locking washer closest to the
-
head of the screw.
-
Tighten screws completely after all screws for that step have been installed.
1
The four support legs must be arranged correctly to properly install the support panels and support bar in later steps.
2
Ensure that all screws on the cabinet base are fully-tighten to avoid screws falling out when the unit is moved.
Once the Grill Probe bracket is secure, ensure the stainless steel tip extends above the lip of the lower cabinet. This reads
3
the internal temperature of the main cabinet. Incorrect placement of the Grill Probe may result in wrong temperature
readings on the Control Board.
4
To change the height between each cooking grid, adjust only when the smoker is completely cooled to avoid injury.
1
Install Locking Caster Wheels (Part #22) to Support Legs (Part #21-2 & 21-4) as shown in Step 2 of assembly.
The support bracket with two holes along the bottom should be on the same side of the unit as the power cord exits the
2
control board (left side). This is important for later steps.
3
Repeat the Support Panel installation for the opposite legs.
Loosen the screw of the power cord clip on the support leg, and guide the power cord through the power cord clip to
4
secure.
Keep water in the water pan at all times while cooking. It will catch grease and drippings from your cooks and allow for
5
easier clean up. If smoking for an extended period, move water pan up higher to allow water to last longer.
6
The logo plate is supplied with one washer and one wing nut.
Unscrew the pre-installed screws from the handle. Place the Wood Chip Tray Lid on top of the Wood Chip Tray base.
7
Secure the assembly with the screws shown in the illustration: base + lid, faceplace, and the handle.
6

ASSEMBLY PREPARATION

GO TO PAGE 62 FOR STEP-BY-STEP ASSEMBLY DIRECTIONS.
IMPORTANT
NOTE

Publicidad

Solución de problemas

loading

Este manual también es adecuado para:

10947