Publicidad
LED Status
The LED indicator is visible through the dark colored transparent connection cover.
The LED indication will give the following statuses.
Normal operation mode
Calibration mode
(closing point adjustment)
Electrical override mode
Perpetual failure mode
Re-Calibration
Re-calibration can be achieved in one of 2 ways:
1. Forced individual actuator re-calibration can also be performed by flipping DIP switch #6
from OFF to ON and back to OFF on the relevant actuator.
2. Forced concurrent re-calibration for all modulating actuators is electrically possible. Within 60
sec. provide the following electrical control signal sequence to the grey wire: 10V-2V-10V-2V-
10V-2V to achieve re-calibration.
After re-calibration the actuator will go into normal operation mode.
Safety Warning. Installation, commissioning and periodical maintenance of the product
must be carried out by qualified operators in compliance with national regulations and/or local
standards. A qualified installer must take all required measures, including use of Individual
Protection Devices, for his and others' safety. An improper installation may damage people,
animals or objects towards which Giacomini S.p.A. may not be held liable.
Package Disposal. Carton boxes: paper recycling. Plastic bags and bubble wrap: plastic
recycling.
K281X032
Full on green
Blinking green
Blinking red/green
Full on red
Designed and produced by FlowCon International ApS
Trafikcenter Allé 17 / 4200 Slagelse / Denmark
Additional information. For more information, go to giacomini.com or contact our technical
assistance service. This document provides only general indications. Giacomini S.p.A. may
change at any time, without notice and for technical or commercial reasons, the items included
herewith. The information included in this technical sheet do not exempt the user from strictly
complying with the rules and good practice standards in force.
Product Disposal. Do not dispose of product as municipal waste at the end of its life cycle.
Dispose of product at a special recycling platform managed by local authorities or at retailers
providing this type of service.
Giacomini S.p.A.
Via per Alzo 39, 28017 San Maurizio d'Opaglio (NO) Italia
consulenza.prodotti@giacomini.com
+39 0322 923372 - giacomini.com
Imported by GIACOMINI U.K.
Unit 2, Goodrich Close, Westerleigh Business Park,
Yate, South Gloucestershire, BS37 5YT.
support@giacomini.co.uk
01454311012
4
Publicidad
