Showroom Mode; Setting The Time; Water Hardness - Teka HLB SC Manual Del Usuario

WARNING
The sensitivity of the touch keys adapts
continually to environmental conditions.
Make sure the surface of the control panel
is clean and free of obstacles when plug-
ging in the oven.
If the clock does not respond correctly
when you touch the keys, unplug the oven
for a few seconds and then plug it in again.
Doing this causes the sensors to adjust au-
tomatically so that they will react once more
to fingertip control.

SHOWROOM MODE

With the DEMO mode activated, you can con-
trol the oven without heating. This mode must
be activated before setting the time on the
clock if it is to be installed in an exhibition with a
mains power connection.
Activating DEMO mode
Press the buttons
on the programing mode, until SHO appears on
the screen.
Then, set the time on the oven.
The letters SHO are displayed for a few sec-
onds every minute to indicate the state of the
appliance.
The oven can be used as normal but it will not
heat up.
To switch off the DEMO Mode, disconnect the
appliance from the mains power supply.

SETTING THE TIME

• To set the time on the oven, the function and
temperature dials must be in the
• When you plug in the oven, you will see the
clock flashing 12:00.
• Touch or
then the minutes. You will hear a double
beep confirming the time is set.
30
User's Guide
and simultaneously
position.
to adjust the hours and
• If you wish to modify the time, touch
until the time starts flashing. Touch
and and follow the instructions in the previ-
ous point.
NOTE
The clock light has a night mode so the display
light will dim between 00:00 and 6:00 hours.
WARNING
In the event of a power failure, your elec-
tronic clock/timer settings will be erased.
If this happens, turn the function and tem-
perature dials to the
The indication 12:00 will show, and you will
then be able to set the time as described
above.
If the oven door was locked before the pow-
er cut, the locked symbol will show until it is
unlocked.
This may take several minutes, depending
on the temperature inside the oven, and
during this time you cannot reset the time.
Once the door is unlocked, you can set the
time as described above.

WATER HARDNESS

• After setting the clock, you need to set the
water hardness.
• The Water Hardness option appears on the
display.
• To change the option rotate the right control.
• Press to confirm the option.
• To modify the water hardness, touch
until the function symbol
• Press to confirm the option.
• Rotate the right control to select the desired
water hardness.
• Press to confirm.
position.
flashes.
or
or