Filling The Water Tank; Emptying The Water Tank - Teka HLB SC Manual Del Usuario

Filling the water tank

OPENING THE FRONT PANEL
• Press the key for a few seconds.
• The front panel slightly opens (≈15º). This
process is slow.
• Complete the panel opening manually.
NOTE
The panel can be opened during the oven
operation.
FILLING THE WATER TANK
All functions require the water tank to be full.
Fill the water tank up to the "MAX" mark with
cold, fresh drinking water and introduce it into
the slot located behind the front panel (maxi-
mum 0,8L).
NOTE
Do not use sterilized or distilled water for
cooking with the steam oven. The miner-
als in the water are essential for the cooking
process to work.
NOTE
When filling the water tank, the top section
of the tank does NOT fully seal. Overfilling
the tank will potentially cause the tank to
leak when moved.
34
User's Guide
REFILLING THE WATER
The contents of the water tank normally suffice
for one cooking session of 50-60 minutes.
If, however, the water tank needs to be refilled,
the Water refill message shows.
Only fill the water tank up to a maximum of
0,5l to ensure that the water does not overflow
when it is pumped back to the water tank. RISK
OF OVERFLOW.

EMPTYING THE WATER TANK

When the appliance is switched off, the residual
water is pumped back into the water tank.
WARNING
The water in the tank may be hot. Danger
of burns!
Depending on the temperature setting and
length of the steam cooking functions, this
can take up to 1 hour to complete. Always
wait until the
fore removing the water tank, attempting
to run a second steam function or switch-
ing off the power to the steam oven. If in-
terrupted before finishing, the pumping
will reset, which can cause the internal
water pump to run dry and make a loud vi-
brating noise while it runs. Over time, this
can cause damage to the pump.
After the water is pumped back to the water
tank, the display will show
ing the following actions:
appear on the display be-
symbol requir-