Read the instructions before installation and use.
The stove must be installed and the gas cylinder stored in accordance with
current regulations.
Do not obstruct the ventilation holes of the cylinder cover.
Do not move the stove when it is operating.
Close the cylinder regulator before moving the appliance.
The tube or flexible hose must be changed within the prescribed intervals.
Use only the type of gas and cylinder specified by the manufacturer.
The cylinder used with your patio heater must meet the following requirements:
Buy liquid butane/propane cylinders only with these required measurements:
Ø30cm x 54.9cm (height) with a maximum capacity of 12.5kg.
In strong wind,pay special attention not to filt the appliacne.
The injector of this device is not removable and is factory assembled. This
appliance is prohibited from converting from one gas pressure to another
pressure.
Do not connect the gas bottle directly to the appliance without a regulator. Use
only the type of gas and the type of cylinder,which are specified in the
instructions.
A regulator (complies with EN16129: 2013 and national regulations) of the
correct pressure corresponding to the category of the appliance.
Use 30 mbar regulator for butane / propane in category I3B / P (30). Use a
30mbar regulator for butane in category I3 + (28-30 / 37)
Use 37 mbar regulator for propane in category I3 + (28-30 / 37). Use a 50
mbar regulator for butane / propane in category I3B / P (50). It is
recommended to use a flexible hose that is approved by EN16436: 2014.
WARNING
18