Heater Stand And Location; Gas Requirements; Leakage Test - Mercalor MT01556 Manual De Instrucciones

HEATER STAND AND LOCATION

The stove is primarily for outdoor use.

Always ensure that adequate ventilation is provided

Always keep an adequate distance from combustible material, ie 100cm at the top and at least

100cm at the sides.
The stove must be placed on a firm and level floor.

Never place the range in an explosive atmosphere such as areas where gasoline or other

flammable liquids or gases are stored.
To protect the stove from strong winds,anchor the base securely to the ground with screws.

.
 Use only propane or butane gas.
The pressure regulator and hose assembly to be used must comply with local standard codes.

The installation must comply with local codes,or in the absence of local codes,with the standard

for the storage and handling of liquefied petroleum gases.
A dented,rusted or damaged cylinder can be dangerous and should be checked by your

cylinder supplier. Never use a cylinder with a damaged valve connection.
 Never connect an unregulated cylinder to the stove.
Range gas connections are leak teted at the factory prior to shiopment. A complete gas

tightness check must be carried out at the installation site,due to possible mishandling during
shipping or the application of excessive pressure to the stovel
Make a soap solution of one part liquid detergetn and one part water. The soap solution can be

applied with a spray bottle,or rag. Soap bubbles will appear in the event of a leak.
The heater should be checked with a full cylinder.

Make sure the safety control valve is in the OFF position. Turn on the gas supply.

 In the event of a leak,shut off the gas supply. Tighten leaking fittings,then turn on gas supply
and recheck.
Never do a leak test while smoking.


GAS REQUIREMENTS

LEAKAGE TEST

21