Publicidad
Idiomas disponibles
Idiomas disponibles
1. Push the mode button to set a limit to the
maximum speed. The white LEDs comes
on to show that the function is on.
2. Push the Mode button again to choose the
next speed level.
Automatic shutdown function
The product is equipped with a shutdown
function that deactivates the product if it is not
used.
To stop the product
1. Release the power trigger or the power
trigger lockout.
2. Push the stop button.
3. Push the release buttons on the battery
and pull the battery out.
18
To use the correct chain oil
WARNING:
oil, which can cause injury to you
and the environment. Waste oil also
causes damage to the oil pump, the
guide bar and the saw chain.
WARNING:
break if the lubrication of the cutting
equipment is not sufficient. Risk
of serious injury or death to the
operator.
WARNING:
chain oil for this function to operate
correctly. Speak to your servicing
dealer when you select your chain
oil.
Note:
This product has an automatic chain
lubrication system. You can also adjust the oil
To adjust the chain lubrication
flow. Refer to
on page 27 .
•
Use only Husqvarna dielectric chain oil.
CAUTION:
below 0°C/32°F some chain oils
become too thick, which can
cause damage to the oil pump
components.
•
Use the recommended cutting equipment.
Recommended cutting equipment
Refer to
on page 31 .
To use the product
•
Hold the product as close to your body
as possible to get the best balance. Use
the harness to support the weight of the
machine and make it easier to handle.
•
Make sure that the tip does not touch the
ground.
•
Do not rush the work, but work steadily
until all the branches have been cut back
cleanly.
•
Always work at full throttle.
Do not use waste
The saw chain can
Use the correct
In temperatures
1744 - 008 -
Publicidad
Solución de problemas
