To Charge The Battery; To Start The Product; To Check Before Starting - Husqvarna MADSAW 525iDEPS Manual De Usuario

To charge the battery

Note:
Charge the battery if it is the first time
that you use it. A new battery is only 30%
charged.
1. Make sure that the battery is dry.
2. Put the battery in the battery charger.
3. Make sure that the green charging light on
the battery charger comes on. That means
that the battery is connected correctly to
the battery charger.
4. When all LEDs on the battery come on, the
battery is fully charged.
5. To disconnect the battery charger from the
mains socket, pull the plug. Do not pull the
cable.
6. Remove the battery from the battery
charger.
Note:
Refer to the battery and battery
charger manuals for more information.

To check before starting

1. Inspect the working area. Remove any
objects that could be thrown out.
1744 - 008 -
2. Check the cutting attachment. Never use
blunt, cracked or damaged equipment
3. Check that the machine is in perfect
working order.
4. Check that all nuts and screws are tight.
5. Make sure the chain is adequately
To adjust the chain
lubricated. See,
lubrication on page 27 .
6. Make sure that the cutting attachment
always stops when you release the throttle/
power trigger.
7. Only use the product for the purpose it was
intended for.
8. Make sure the handle and safety features
are in order. Never use a machine that has
any parts missing or has been modified in
relation to the specification.

To start the product

1. Push and hold the start button until the
green LED comes on.
2. Use the power trigger to control the speed.
To limit the maximum speed with the
mode button
The product has a mode button. Withe
the mode button the operator can limit the
maximum speed. The mode button has 3
speed levels. A lower level increases the time
of operation for the product. The mode button
has 3 speed levels. A lower level increases
the time of operation for the product. Use level
1 and level 2 if the operation does not require
full speed/full power. If the operation condition
requires full speed/full power, use level 3. Do
not use a higher level than necessary for the
operation.
17