Publicidad
Idiomas disponibles
Idiomas disponibles
GENERAL
1. Only use this tool for cutting wood, cutting aluminum is possible only with a special separate saw blade.
2. Always saw a single work piece (work pieces placed one on the other or next to each other cannot be
properly clamped which may result in saw blade binding or work piece slipping during sawing).
3.Inrush currents cause short-time voltage drops; under unfavorable power supply conditions, other
equipment may be affected (if the system impedance of the power supply is lower than 0,295 + j0,184
Ohm, disturbances are unlikely to occur); if you need further clarification, you may contact your local power
supply authority.
4.Always disconnect plug from power source before making any adjustment or changing any accessory.
5.This tool should not be used by people under the age of 16 years.
6.This tool is not suitable for wet cutting.
OUTDOOR USE
When used outdoors, connect the tool via a fault current (FI) circuit breaker with a triggering current of
30 mA maximum, and only use an extension cord which is intended for outdoor use and equipped with a
splash proof coupling-socket.
BEFORE USE
1.Always check that the supply voltage is the same as the voltage indicated on the nameplate of the tool.
2.Use completely unrolled and safe extension cords with a capacity of 16 Amps (U.K. 13 Amps).
3.Always mount the tool on a flat and stable working surface (e.g. workbench).
4.Wear protective glasses, hearing protection, and protective gloves.
5.Dust from material such as paint containing lead, some wood species, minerals and metal may be harmful
(contact with or inhalation of the dust may cause allergic reactions and/or respiratory diseases to the
operator or bystanders); wear a dust mask and work with a dust extraction device when connectable.
6.Certain kinds of dust are classified as carcinogenic (such as oak and beech dust) especially in conjunction
with additives for wood conditioning; wear a dust mask and work with a dust extraction device when
connectable.
7.Follow the dust-related national requirements for the materials you want to work with.
8.Do not work materials containing asbestos (asbestos is considered carcinogenic).
9.Never use the tool without the original protection guard system.
10.Check the protective guard for proper closing before each use.
11.Do not operate the saw if the protective guard does not move freely and close instantly.
12.Never clamp or tie the protective guard into the open position.
13.Always firmly clamp the work piece (do not work with pieces that are too small to clamp).
14.Always support the free ends of a long work piece.
15.Never allow another person to hold or support the work piece while working; use the saw table
extension.
16.Never use the tool without the table insert; replace a defective or worn table insert
17.Remove all obstacles on top of as well as underneath the cutting path before you star.t cutting.
18.Avoid damage that can be caused by screws, nails and other elements in your work piece; remove them
before you start working.
ACCESSORIES
1.Never use grinding/cutting discs with this tool.
2.MAXPRO can assure flawless functioning of the tool only when the correct accessories are used which can
be obtained from your MAXPRO dealer.
3.For mounting/using non-MAXPRO accessories observe the instructions of the manufacturer concerned.
4.Use only accessories with an allowable speed matching at least the highest no-load speed of the tool.
5.Never use saw blades made of high speed steel (HSS).
5
GB
Publicidad
