Installing The Blades; Installing The Light Kit Pan - Hinkley 60 DRAFTSMAN Manual De Instrucciones

INSTALLING THE BLADES

NOTE:
Remove any rubber supports that are
installed for shipping.
Install the blade to blade bracket by using the screws and
1
spacers provided .
Tighten each screw securely.
2
3 Install the blade assembly to motor by inserting the blade
bracket into the slot of the flywheel, aligning the holes on blade
bracket with the holes on the flywheel, install the blade bracket
with screws provided. Tighten screw securely.
Repeat steps 1,2 & 3 for the remaining blades.
4

INSTALLING THE LIGHT KIT PAN

CAUTION: To reduce the risk of electrical shock, disconnect the
electrical supply circuit to the fan before installing the light kit.
Loosen but do not remove two of three mounting screws from
1
the fan motor assembly; Remove one mounting screw.
Push the light kit pan up to the fan motor assembly so that
2
the two loosened screw heads fit into the keyhole slots. Turn
the light kit pan clockwise, tightened the screws. Re-install the
screw that was removed in step 1 and tighten firmly.
10 hinkley.com
Spacer
Screws Blade Arm
LK Pan
Screws
Blades
Screws