Operation - Hinkley 60 DRAFTSMAN Manual De Instrucciones

OPERATION

Your DC brushless motor is equipped with an
automatically learned type remote control.
There is no frequency switches on the receiver
or transmitter. The fan can start to use once
the pairing process is done.
Remove the panel from the transmitter and
then install one 2032 battery (included). You
need to use a coin to open or close the battery
cover. To prevent damage to transmitter,
remove the battery if not use for long periods
of time (Fig. 1)
WARNING: Chemical Burn Hazard.
Keep batteries away from children.
This product contains a lithium button/coin cell
battery. If a new or used lithium button/coin cell
battery is swallowed or enters the body, it can
cause severe internal burns and can lead to
death in as little as 2 hours. Always completely
secure the battery compartment. If the battery
compartment does not close securely, stop
using the product, remove the batteries,
and keep it away from children. IF you think
batteries might have been swallowed or placed
inside any part of the body, seek immediate
medical attention.
The batteries shall be disposed of properly,
including keeping them away from children;
Even used cells may cause injury.
14 hinkley.com
1
button:
Press this button and release instantly
to turn on or off the light.
button:
2
Press and hold to dim or brighten
lights to the desired level and release.
button:
3
Press this button to set fan wind
direction up or down.
button:
4
Press button for turn on and setting
1-6 fan speed.
button:
5
Press this button to turn the fan on/off.
Signal light (Fig. 2)
6
Pairing Process
NOTE: If installing/pairing more than
one fan in an area, the power must be
disconnected from all fans except the
one fan being paired.
With the fan's power off, restore power to
the fan. Press and hold " " button for
about 5 seconds and release. If optional
light kit is installed, the light kit will flash
three times and the motor spin up for
10 seconds on low speed. The fan has
completed the pairing process with the
wall control and is ready for use.
NOTE: A single fan can be controlled
with asmany as 3 wall controls in
one room. Every control will need to
repeat the pairing process based on
instructions above and all controls must
be within 30 feet of the fan.
Figure 1
Signal light
Figure 2
HIRO Control System
ON
OFF