Preparation; Installing The Hanging Bracket - Hinkley 60 DRAFTSMAN Manual De Instrucciones

PREPARATION

PREPARATION:
Verify you have all parts before beginning the installation. Check pulp
paper insert closely for missing parts. Remove motor from packing. To
avoid damage to finish, assemble motor on soft padded surface or use
the original pulp paper insert in motor box.
DO NOT LAY MOTOR HOUSING ON ITS SIDE AS THIS COULD RESULT IN
SHIFTING OF MOTOR IN DECORATIVE ENCLOSURE.

INSTALLING THE HANGING BRACKET

CAUTION: To avoid possible electrical shock, be sure electricity is
turned off at the main power box before wiring. All wiring must be in
accordance with National and Local Electrical Codes and the ceiling fan
must be grounded as a precaution against possible electric shock.
Locate ceiling joist where fan is to be mounted, being sure location
1
agrees with the requirements in the minimum clearance section
of this guide. Wood joists must be sound and of adequate size to
support 35 pounds (See page 2, items 3 and 4).
If not already present, mount a UL listed outlet box marked
2
"suitable for fan support" following the instructions provided with
the outlet box. The outlet box must be able to support a minimum
of 35 pounds.
Remove the canopy ring from the canopy by turning the ring
3
counter-clockwise until it unlocks. Remove the mounting bracket
from the canopy by loosening the four screws on the top of the
canopy. Remove the two non-slotted screws and loosen the
slotted screws. This will enable you to remove the mounting
bracket.
4 Attach hanging bracket to outlet box using screws provided with
the outlet box.
Downrod
Motor housing
LK pan
Shade
Parts identification on assembled fan.
Screws
Figure 1
Outlet Box
Hanger
Bracket
Flat Washer
Spring Washer
Outlet Box Screw
Figure 2
©2022 Hinkley Lighting, Inc. hinkley.com
Canopy
Yoke cover
Blade
Blade arm (imbedded)
Hanger
bracket
Canopy
Trim Ring
5