Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
Dear Customer, thank you for choosing an IBEA product. This machine was
designed exclusively for harvesting fruit such as olives, almonds, co ee and similar.
Like all our products, this one has been subjected to precise and severe tests which
will guarantee use for many years. An extensive spare parts distribution and technical
assistance service will follow you in the maintenance of your tool.
User manual description
This manual has been prepared in compliance with the indications contained in the Machinery
Directive 2006/42 / EC and subsequent amendments and additions and is an integral and
essential part of the machine. This manual must be kept together with the machine, in a
sheltered and accessible place for prompt consultation; must accompany the machine
throughout its life, from initial testing to nal disposal.
This user's manual is intended to:
• Describe the operation and conditions of use of the machine.
• Illustrate the main technical characteristics of the machine.
• Provide instructions for use.
• Highlight potential risks and / or possible dangerous situations.
• Provide maintenance and repair instructions.
• Enable understanding of any operational problems and ways to solve them.
In addition to observing the requirements contained in this manual, the use of the
machine is subject to compliance with all safety regulations.
Assembly
Ref. g. B
Hold the head T and position the pole with the wiring, near the lower part A, as shown in the
gure. Connect the socket of the xed rod M to the socket of the head B by inserting it as far as
it will go. Insert the rod into the appropriate seat in part A, making sure to slide the cable
inside the pole itself. Push up to the internal stop and then, using the special 3 mm wrench
supplied, tighten the 4 screws C to obtain a single, rmly xed head-rod body. The machine
shaft is telescopic. To lengthen or shorten the rod, use lock N. Open lever P to free the rod.
Adjust the desired length and lock the lever P again. If the rod is not properly locked, open the
lever P again, slightly tighten the screw Q and lock the lever.
33
Publicidad
