Publicidad
Idiomas disponibles
Idiomas disponibles
14.3 Electrical Connection
Dangerous electrical voltage! Improperly performed electrical work can result in
serious injury or death. Therefore, electrical work may only be carried out by
qualified and authorized personnel for low-voltage work! The warranty does not
cover damage caused by improper connection.
Before the first use:
Make sure that the voltage of the mains supply cable and the motor voltage match.
Make sure that the mains to which the machine is to be connected is properly earthed and
complies with the applicable safety standards.
Regularly check the condition of the power cord, switch and cable gland.
Never operate the unit with a damaged cable.
Use a cable drum with cross-section and length according to the performance of the device
and unwind it completely.
Never pull the plug by pulling the cable, but always by pulling the plug out of the socket.
After making the connection, check that the grinding wheel and brush rotate in the same
direction as indicated by the arrow on the housing.
OPERATION
15.1 Check before initial start-up
Before initial operation, check:
whether the guards are in place, intact and in good condition.
that the moving parts are functioning properly and that there are no damaged parts.
whether the grinding wheel and brush are intact.
whether the machine is securely anchored.
whether the machine is functioning properly when idle.
15.2 Check before each use
Before operation, check:
whether the wheel and brush clamping nuts are firmly tightened.
whether the grinding wheel and brush are intact and in good condition.
Pay attention to the surface temperature of the drum during continuous operation - danger of
burns!
15.3 Mounting the Grinding Wheel
The diameter of the disc decreases with increasing wear and the distances become larger.
Therefore, spark protection and workpiece support must be readjusted from time to time in
accordance with the wear of the disc in order to maintain the specified distance from the
peripheral edge of the disc.
HOLZMANN MASCHINEN GmbH
WARNING
www.holzmann-maschinen.at
Mount the spark arrester (8) on the wheel arches
(1, 6) and set a maximum distance of 5 mm from
the peripheral edge of the grinding wheel.
2 Attach the protective cover (7) to the spark
arrester (8) and adjust to protect the operator.
Attach the workpiece support (10) to the disc
boxes (1, 6) and set a maximum distance of 2 mm
from the peripheral edge of the disc.
OPERATION
24
DSM200DS
Publicidad
