HOLZMANN MASCHINEN DSM200DS Instrucciones De Servicio página 29

TROUBLESHOOTING
Danger due to electrical voltage! Manipulating the machine with the voltage
source connected upright can result in serious injury or death. Disconnect the
machine from the power source before you begin work to eliminate defects!
Fault
Motor does not start
Motor overheated
Engine stuck
Machine becomes slow
during operation
Machine vibrates
Wavy surface of the
workpiece
Scratches on the surface
of the workpiece
Spraying sparks or cracks
in the workpiece
Grinding wheel quickly
becomes blunt, grain falls
out
Grinding wheel "clogged",
workpiece has
combustion markings
HOLZMANN MASCHINEN GmbH
Possible Cause
 Low voltage
 Open circuit in motor or loose
connections
 Short-circuit in cable or plug
 Motor overloaded
 Short circuit in motor or loose
connections
 Low voltage
 Incorrect fuse or circuit breaker in
circuit
 Motor overloaded
 Pressure too high
 Dirt on rotating parts
 Unequal wear of the grinding
wheel
 Machine not mounted on a solid
surface.
 To hard grinding wheel or to high
feed speed
 Contamination on the surface of
the pane
 Workpiece is not sufficiently held
in place
 Incorrect grinding wheel
 Incorrect delivery
 No or too little) Coolant required
 Cutting depth too large
 grinding wheel is too soft for the
material to be machined
 Grinding wheel diameter too small
 Poor post-treatment of the
grinding wheel
 Defective grinding wheel bond
 Grinding wheel is too hard
 Coolant required.
www.holzmann-maschinen.at
WARNING








TROUBLESHOOTING
Correction
Check mains voltage
Check line connections on the
motor for loose or open
connections.
Check plug for damaged
insulation and short-circuited
wires.
Reduce motor load
Check motor connections for
loose or short-circuited
terminals or burnt-out
insulation.
Correct low voltage
Install the correct fuse or
circuit breaker.
Reduce motor load
 Decrease pressure
 Cleaning
 Dressing the wheel
 Check whether the machine
has been securely mounted
on a solid surface and/or use
a holder to hold the
workpiece securely in place.
 Use softer grinding wheel or
reduce feed speed
 Clean the surface of the
grinding wheel
 Use a holder to hold the
workpiece securely in place.
 Use softer grinding wheel or
grinding wheel with coarser
grain size
 Reduce the infeed of the
workpiece into the grinding
wheel.
 Add coolant system or add
coolant manually
 Reduce the infeed of the
workpiece into the grinding
wheel.
 Select a softer bond
 Replace grinding wheel
 Treating the surface of the
grinding wheel
 Contact the manufacturer of
the grinding wheel.
 Choose a softer bond
 Add coolant system or add
coolant manually
29
DSM200DS