Publicidad
Idiomas disponibles
Idiomas disponibles
GB | Wireless Sensor
Technical Specifications
outdoor temperature: -30 °C to +60 °C, 0.1 °C resolution
temperature measurement accuracy:
±1 °C for 20 °C to +24 °C range
±2 °C for 0 °C to +20 °C and 24 °C to +40 °C range
±3 °C for -20 °C to 0 °C and 40 °C to +50 °C range
±4 °C for other ranges
indoor and outdoor humidity: 1–99 % RH, 1 % resolution
humidity measurement accuracy: 5 %
wind sensor measurement range: 0 to 127.5 km/h
unit of wind speed: km/mph
precipitation sensor measurement range: 0 to 2,999 mm
unit of precipitation: mm/inch
radio signal range: up to 100 m in an open space
transmission frequency 433 MHz, 10 mW e.r.p. max.
temperature/humidity/wind sensor power supply: 4× 1.5 V AA (not included)
temperature/humidity/wind sensor dimensions and weight: 275 × 135 × 310 mm, 377 g (without
batteries)
Sensor Description
See fig. 1
1 – wind sensor cups
2 – compass
3 – wind direction paddle
4 – temperature/humidity/wind sensor battery compartment
Buttons: TX – send signal from sensor to station
1/2/3 – switch sensor channel number
WAVE – manual activation/deactivation of DCF signal reception
5 – mounting rod (26 mm diameter)
6 – mounting base
Station Description
See fig. 2
1 – CHANNEL button
– search for sensor signal/browse through readings from individual con-
nected sensors
2 – power adapter socket
3 – battery compartment
Getting Started/Installation
1. Connect the adapter to the station, then insert batteries first into the weather station (3× 1.5 V
AAA), then into the wireless temperature/humidity/wind sensor (4× 1.5 V AA).
2. When inserting the batteries, make sure the polarity is correct to avoid damaging the weather
station or sensor. Only use alkaline batteries of the same type; do not use rechargeable batteries.
3. Place the two units next to each other. The weather station will automatically detect the signal
from sensors within 3 minutes. If signal from sensors is not detected, long-press the CHANNEL
button on the weather station to repeat the search and press the TX button on the sensor.
4. To ensure correct measurement, the temperature/humidity/wind sensor and precipitation
sensor must be placed above the ground (at least 1.5 m) onto a horizontal surface and outside
of buildings and structures. The sensor must be mounted firmly to prevent its damaging. First,
screw the mounting plate onto a level surface, then mount the mounting rod into it. Screw the
temperature/humidity/wind sensor onto the rod. Wind must flow freely around the wind sensor
from all sides. Check that the wind direction indicator and paddles for measuring wind speed can
3
Publicidad
