Safety Instructions And Warnings - Emos E06016 Manual De Instrucciones

rotate freely. The north arrow (N) on the built-in compass must point to the real north. Otherwise,
wind direction will always be displayed incorrectly. When choosing a suitable place for mounting
the sensor, check before installation that the main station is within range of the sensor. The range
of the sensor may decrease substantially in areas with large number of obstacles.
5. Do not place the sensor onto metal objects; doing so will reduce the transmission range.
6. If the low battery icon
Switching Channels and Connecting Additional Temperature/Humidity/Wind
Sensors
1. Select channel 1, 2 or 3 for the sensor by repeatedly pressing the CHANNEL button. Then, long-
press the CHANNEL button. The
2. Remove the cover from the battery compartment on the rear of the sensor and set the sensor
switch to the desired sensor channel number (1, 2, 3), then insert batteries (4× 1.5 V AA). Data
from the sensor will be loaded within 3 minutes.
3. If sensor signal is not found, remove the batteries and follow steps 1 and 2 again or press the
TX button.
Attention:
The anemometer (wind speed and direction measurement) only functions on channel 1 (spare
sensor E06016).
Channels 2 and 3 are used for information about outdoor temperature and humidity (spare sensor
E06018).

Safety Instructions and Warnings

Read the user manual before using the device.
The product is designed to serve reliably for many years if used properly.
• Read the manual carefully before using this product.
• Do not expose the product to direct sunlight, extreme cold and humidity, and sudden changes
in temperature.
• Do not place the product in locations prone to vibration and shocks – may cause damage.
• Do not subject the product to excessive force, impacts, dust, high temperatures or humidity –
doing so may cause malfunction, shorten battery life, damage batteries and deform plastic parts.
• Do not expose the product to rain or moisture if it is not designed for outdoor use.
• Do not place any open flame sources on the product, e.g. a lit candle, etc.
• Do not place the product in places with inadequate air flow.
• Do not insert any objects in the product's vents.
• Do not tamper with the internal electric circuits of the product – doing so may damage the product
and will automatically void the warranty.
• To clean the product, use a slightly moistened soft cloth. Do not use solvents or cleaning agents
– they could scratch the plastic parts and cause corrosion of the electric circuits.
• Do not submerse the product in water or other liquids or expose it to dripping or splashing water.
• If the product becomes damaged or defective, do not perform any repairs yourself; bring it for
repair to the store where you bought it.
• This device is not intended for use by persons (including children) whose physical, sensory or
mental disability or lack of experience and expertise prevents safe use, unless they are supervised
or instructed in the use of the appliance by a person responsible for their safety.
Do not dispose with domestic waste. Use special collection points for sorted waste. Contact
local authorities for information about collection points. If the electronic devices would be
disposed in landfill, dangerous substances may reach groundwater and subsequently food
chain, where it could affect human health.
Hereby, EMOS spol. s r.o. declares that the radio equipment type E06016 is in compliance with Directive
2014/53/EU. The full text of the EU declaration of conformity is available at the following internet
address: http://www.emos.eu/download.
is displayed, replace batteries in the sensor or weather station.
icon will begin flashing.
4