GYS NEOMIG-i 400 G Manual De Uso página 18

User manual
USING EXTENSION LEADS
All extension leads must be of a suitable length and width that is appropriate to the equipment's voltage. Use an extension lead that complies with
national safety regulations.
Input voltage
400 V
CONNECTING OF THE INTERCONNECTION CABLE
Make sure the main welding power source switched off when connecting or disconnecting the wire feeder. Ensure the machine is
unplugged from the mains, and then wait 2 minutes.
For details of the wiring harness connection between the generator and the wire feeder, please refer to the separate wire feeder manual (optional).
The diagrams below describe the minimum requirements for the various different welding processes. The user can leave any unused connections (gas
connection in MMA welding, power cable on the wire feeder in MMA and TIG welding, etc.) if they wish.
MIG-MAG welding (positive polarity)
KOOLWELD 2 optional
18
Translation of the original
instructions
Length - Cross-section of the extension cable (Length < 45m)
4mm²
NEOMIG-i 400 G / 500 G