Publicidad
Idiomas disponibles
Idiomas disponibles
1
About this document
• The instructions and information in this manual form an
integral part of the equipment and describe its safe and
intended use.
• Keep this manual in the immediate vicinity of the installation.
• Hand this manual to any subsequent owner or installer.
• The instructions and specifications only apply to the equip-
ment described in this manual.
• Technical changes may be made without notice in the interest
of product development.
2
Warnings notices and symbols
Warning notices
and symbols
Direct/Immediate danger to life and/
or health
Danger!
Possible Danger to life and/or health.
Warning!
Important information. You should
observe this information to ensure
correct and save operation. Possible
Danger of physical harm and/or material
NOTE
damage may otherwise result.
3
Safety
Observe the safety rules in this manual. Safety measures are listed
in this section.
Intended use
• The equipment described in this manual is intended for use
with a Franklin Electric submersible motor.
• A correctly sized pump must be fitted to the motor.
• Pump and motor must operate under water only.
• The pumping system must fulfill the applicable directives,
regulations and statutory provisions.
Loss of guarantee and liability exclusion
Franklin Electric shall not be liable for the damage resulting from
any non-intended use. The risk of such use rests solely with the
user.
Installer group
Must be installed by professional staff only (qualified electrical
technician).
General safety instructions
The following safety instructions must be observed prior to putting
the control gear into use:
• Mount the control gear in an appropriate location, orientation
and position.
• Do not modify the control gear or its electrical or mechanical
connections.
• Do not remove any part or parts of the control gear.
• Never install any control gear with a known defective motor.
• Remove power before working on control gear. Switching off
power is not sufficient.
4
EN
Meaning
• Make sure that nobody can switch on power unexpectedly
while work is being conducted.
• Never work on electrical systems during a thunderstorm.
• Only qualified professional staff (qualified electrical
technician).
• Replace all protection and safety devices after completing
work.
• Ensure that all electrical connections and safety devices have
been checked and that all fuses, circuit breakers, and other
safety devices have been set correctly before switching on.
• Make sure that no danger zones are accessible (e.g. electrical
connections).
• Read the pump manufacturer's commissioning instructions
before switching on any control gear.
• Repairs must only be conducted by authorized professional
workshops. Use original Franklin Electric spare parts only.
4
Storage, transport, and disposal
Storage
•
Do not remove the control gear from its original packaging
until the time of installation.
•
Keep this manual with the control gear for future use.
•
Do not store in direct sunlight or close to any heat source.
Transport
Observe temperature and humidity specifications during periods of
transport (-10°C to +55°C non-condensing).
Unpacking
After unpacking, check for physical damage that may impact on the
safety of the control gear, such as a damaged enclosure, dislodged
cable glands, etc. Dispose of all packaging material observing local
regulations.
This product contains electrical and electronic com-
ponents. When needed, dispose of components
and control gear observing local, regional, and
national regulations.
5
Technical specifications and model parameters
The tables below summarize technical attributes, specifications
and model series parameters of the 3-wire Control box. Models
may differ with respect to current overload characteristics, detailed
capacitor sizes and motor currents. The connector terminals are
suitable for copper (Cu) wire only.
Power ratings and model numbers
Motor Rating
Motor
Control Box
[kW]
Mod. No.
0,25
214 753 ****
280 355 2115
0,37
214 755 ****
0,55
214 757 ****
280 357 2115
0,75
214 758 ****
280 358 2115
1,1
224 750 **** 282 350 8114
1,5
224 751 ****
282 351 8114
2,2
224 752 **** 282 352 8114
3,7
224 753 **** 282 253 4014
DISPOSAL
Start-
Capacitor
Capacitor
Mod. No.
220V [μF]
370V [μF]
48
65
95
115
208
300
208
45/30
Run-
-
-
-
-
10
20
35
Publicidad
