SICK RSB Manual De Instrucciones página 28

OPERATING INSTRUCTIONS
4.1.1 Mounting with adhesive back brackets
en
4.2 Designing own mounting brackets
28 O P E R A T I N G I N S T R U C T I O N S | RSB - Roller Sensor Bar
RSB1- Type
xxxxxxxxxxxxxxxxx
xPxx
P0D BEF-AP-RSBCON
P0A, P0B, P0C BEF-AP-RSBKIT
and P0D
NOTICE
The dimensional drawings of the different mounting brackets are shown in
sional drawings", page 39.
Applicable to models RSB1-xxxxxxxxxxxxxxxxxxP0A and RSB1-xxxxxxxxxxxxxxxxxxP0C:
Installation:
1. Clean and dry the bonding surfaces to obtain optimal adhesion.
NOTE
Typical cleaning solvents are methyl ethyl ketone for metals or isopropyl alcohol for
plastics.
2. Attach the bracket to the surface once the adhesive surface is clean and dry.
3. Let the bracket cure for 60-minutes before mounting the Roller Sensor Bar.
NOTICE
P0A + P0C:
Adhesive mounting brackets can withstand a force up to 70 Nm.
To design your own mounting brackets for the RSB, use the following diagram of the
star pattern mounting specifications.
Part number Picture / Description
2127768
Between hex sections snap
2127759 This kit includes 1 pair of each
standard mounting bracket (P0A,
P0B, P0C and P0D)
"Dimen‐
8027085/2022-05-31 | SICK
Subject to change without notice