Cleaning - Vornado VFANJR Manual De Instrucciones

PEDESTAL ASSEMBLY & ADJUSTMENT
CONT'D
4. Adjust to desired pole length and rotate collet thumb screw clockwise to
secure two poles together.
5. Insert top of upper pole into recess on underside of yoke cap. Use hex
wrench to tighten set screw on back side of yoke cap.
6. With circulator still resting on soft surface, insert lower pole into recess on
top of base. From underside of base, fully tighten thumb screw to secure.
10 English
7. With one hand supporting circulator head and one hand on pole, lift
VFANSRP (VFAN SR Pedestal) upright.
To adjust height of circulator:
Note: Before adjusting height, check that power cord is
not tangled and is able to move freely.
1. Support circulator head with one hand. Use other hand
to loosen thumb screw.
2. Adjust pole to desired height and secure into position
by fastening thumb screw.
Note: After adjusting height, ensure that thumb screw is
fully tightened to ensure circulator head does not fall.

CLEANING

Because your Air Circulator moves a substantial amount of air, it will need regular cleaning. To avoid risk of fire, electrical shock, or injury to persons, unplug the
unit before any cleaning activity.
The motor is permanently lubricated and requires no oiling.
To clean motor cap and inlet ribs: Use a common household vacuum. Do
not use water to clean these parts of the Air Circulator.
To clean grille: Remove grille (See GRILLE REMOVAL instructions) and dust or
wash with a mild dishwashing soap. Do not place grille in the dishwasher. The
excessive heat can remove the plating.
To clean blade: Wipe with a damp cloth. If your Air Circulator is used in a
greasy environment, such as a kitchen, mild soap or a common household
cleaner may be necessary. Do not use solvents.
To clean base: Wipe with a damp cloth.
11
English