Descargar Imprimir esta página

Manual Unscrewing Of The Blind Rivet Nut; Setting A Blind Rivet Nut; Troubleshooting; Blind Rivet Nut Is Not Screwed On - Gesipa FireBird Pro S GE Manual De Instrucciones

Ocultar thumbs Ver también para FireBird Pro S GE:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 38
GB
2.5

Manual unscrewing of the blind rivet nut

Manual unscrewing of a blind rivet nut may be necessary if:
The blind rivet nut was not screwed on straight before the setting operation, or the thread
of the blind rivet nut or threaded mandrel 1 is defective;
The thread is deformed after the setting operation and the tool does not unscrew automa-
tically (selected setting stroke too high, wrong setting!) and cuts out due to overloading.
Æ Remove the battery. Then unscrew the threaded mandrel by hand. To do this, insert
the hexagon screwdriver WAF 4 into the hexagon socket of the tool (see Figure 5),
possibly after removing the accessory magazine (Figure 5), if necessary. Carefully loosen
threaded mandrel A by screwing in anti-clockwise direction. After unscrewing the defor-
med nut, insert the battery into the tool again and remove the hexagon screwdriver. Press
and release switch I to bring the tool back to Home position in a slow reference run.
Important: Set the correct setting stroke as described in 2.3.
2.6

Setting a blind rivet nut

Insert the correctly fitted nut into the hole of the workpiece as far as it will go using the
blind rivet nut setting tool.
Start the setting operation by pressing switch I. The setting operation runs until the set
setting stroke is reached before the set blind rivet nut is unscrewed again automatically.
3.

Troubleshooting

3.1

Blind rivet nut is not screwed on

Possible causes
Nut thread defective
Threaded mandrel defective
Nut does not rest against nose-
piece
Nut unscrews again
Battery is discharged
24
Corrective measures
Use new nut
Replace threaded mandrel (section 2.1)
Threaded mandrel length x incorrect; adapt to nut length (section 2.2)
Hold switch I pressed until the tool comes to a standstill (section 2.5)
Charge the battery

Publicidad

loading