Charging The Battery - Dogtra Europe 640C Manual De Instrucciones

7. CHARGING THE BATTERY

The Dogtra 640C uses Lithium-Polymer batteries.
1. Charge the unit before using the unit for the first time.
2. Do not charge the batteries near any flammable
substances.
3. Fully charge the batteries if the unit is to be stored
without use for a period of 3 months or more.
Recharge the unit if :
1. The indicator light on the collar is emitting a red color.
2. If the 3 bar indicator on the transmitter LCD shows just
1 bar.
3. The indicator light on the transmitter or receiver will
not come on. The indicator light on the transmitter or
receiver comes on momentarily, but will not stay on
when the "Constant" button is pushed.
Battery Charging Procedure
NOTE : The unit has a partial charge when it leaves the
Dogtra facility, upon receipt of the collar, be sure to give
it a full 2-hour initial charge before the first use.
50
1. Attach the charging cables to both the transmitter and
receiver(s), as shown on page 50.
2. Plug the charger into a 230-volt wall outlet or if using
the accessory field charger, plug into a cigarette lighter
only for Lithium-Polymer batteries. When properly
plugged in, all indicator lights should glow red. During
the charging process, the unit will shut off. Once the
battery cable is unplugged from the unit after a full
charge, you will need to turn the unit on again before use.
3. The Lithium-Polymer battery is fully charged within
2 hours. The lights will stay red during the charging
process. The red light will change into a steady green light
when the battery is fully charged (when you disconnect
the charger after finishing the charge, you will need to
restart the unit).
4. After charging, cover the battery charging receptacles
with the rubber plugs on the transmitter and receiver/
collar.
NOTE : Only use Dogtra-approved batteries, chargers, and
accessories for your Dogtra e-collars. When a charger is
not in use, disconnect it from the power source.
51