Installation; Boiler Fixing - Riello 40 FS10 G.T. Instrucciones De Instalación, Montaje Y Funcionamiento

TEST BOILER
The working field has been defined according to EN 676 standard.
COMMERCIAL BOILERS
The burner-boiler matching is assured if the boiler conforms to EN 303 and the combustion chamber dimensions
are similar to those shown in the diagram EN 676. For applications where the boiler does not conform to EN 303,
or where the combustion chamber is much smaller than the dimensions given in EN 676, please consult the
manufacturers.
CORRELATION BETWEEN GAS PRESSURE AND BURNER OUTPUT
To obtain the maximum output, a gas head pressure of 5.8 mbar is measured (M2, see chapter 3.3, page 4) with
the combustion chamber at 0 mbar using gas G20 with a net heat value of 10 kWh/Nm
7
6
5
4
3
2
1
40
D5257
40,000
3.

INSTALLATION

THE BURNER MUST BE INSTALLED IN CONFORMITY WITH LEGISLATION AND LOCAL STANDARDS.

3.1 BOILER FIXING

IMPORTANT
Boiler door must have a max. thickness of 90 mm,
refractory lining included.
If thickness is greater (max. 150 mm), a combustion
head extension must be fitted, which is supplied
separately.
HINGE
ASSEMBLY
50 60 70
50,000 60,000
S7392
80 90 100
70,000 80,000
Separate the combustion-head assembly

from the burner body by removing nut (1) and
removing group (A).
Fix the head assembly group (B) to the boiler

(2) insert the supplied insulating gasket (3).
A
3 GB
(8,570 kcal/Nm
3
110 120 kW
90,000 100,000 kcal/h
Thermal power
1 3
B
).
3
2
D5108
20027965