2. NON-DRIVE SIDE INStALLAtION
2.1.
Place a 0,5mm plastic washer onto the axle.
2.2.
Select the appropriate spacer(s) for the non-drive
side in page 27 (road) or 28 (MTB) and place
them into the axle following the 0,5mm plastic
washer.
2.3.
Introduce the non-drive assembly into the frame
through the bearing and frame.
Spacer selected in page 27-28
USER MANUAL - CRANK INSTALLATION
3. DRIVE SIDE INStALLAtION
3.1.
Grease the right end of the axle.
3.2.
Select the appropriate spacer(s) for the drive
side in page 27 (road) or 28 (MTB) and place it
between the frame and the drive side crank.
Spacer selected in page 27-28
0,5mm Plastic washer
ES
EN
35