Ultenic T10 Manual Del Usuario página 8

Replace the main brush and snap the cover back into place.
Note:
It is recommended to replace the main brush every �-�� months depending on use.
�. Maintaining the Dustbin/ Water Tank
Press the dust bin release button and
remove the dust bin.
Remove the primary filter and HEPA
filter, wipe down the surface with a dry
cloth or use the cleaning tool. Rinse the
primary filter with water and let dry.
Pour out the remaining water in the
water tank and dry the water tank.
Open the dust bin and empty contents.
Remove the mop pad to wash and dry
in the sun.
After the filter, dust box, mop cloth and
water tank are all dried, put them back
together for next use.
�. Maintaining Sensors, Charging Contacts and Omnidirectional Wheel
Use a damp cloth to clean all sensors on the Robot.
Use a dry cloth to clean the
charging contacts on the Robot
(alcohol is not recommended).
Note:
Do not clean the omnidirectional wheel with water.
�. Maintaining Auto Empty Base
Auto Empty Base Dust Bag
The Auto Empty Base will indicate when the dust bag is full on the smart LED display panel (Dust
bag indicator " " will be green). Discard of dust bag once full and replace dust bag with a new
one.
Open cover and pull Discard the old
up the dust bag from dust bag
handle
Remove any trapped hair or debris from
the omnidirectional wheel with the
cleaning brush provided.
Replace with new
Close cover
dust bag & fully
lower cardboard
handle