Publicidad
Idiomas disponibles
Idiomas disponibles
HEATER SET-UP:
1.
After the heater has been removed from its package, remove
the back panel from inside the back cavity.
2. Place the filled gas cylinder into the back of the heater with the
valve facing
3. Screw the correct regulator onto the outlet of the gas cylinder
valve
clockwise.
on until the nut is fully
4. IMPORTANT TEST for leaks:
This must be carried out in a well-ventilated area, free from any
open flame or other sources of ignition. With the regulator
connected to the cylinder valve 1 and 1/2 turns
Brush all hose connections, pipe connections to the gas valve,
regulator connection to the cylinder and gas cylinder valve
with a 50:50 solution of detergent and
bubbles forming is an indication of a leak. lf a leak is found, turn off
the cylinder valve
gas cylinder and remove the gas cylinder to a cool, outdoor well
ventilated area. Contact your dealer or gas supplier for
DO NOT USE THE HEATER IF A LEAK IS FOUND.
DO NOT USE A NAKED FLAME FOR LEAK TESTING.
Warning: DO NOT COVER
This symbol on the top part of the device warns the
user that in order to avoid overheating and a fire
hazard,
DO NOT COVER the
CAUTION:
HOT SURFACE! DO NOT TOUCH!
This symbol on the device warns burning or
scalding to the user this part of the heater must
NOT be touched when it is in
outwards.
Turn by hand
home.
(clockwise),
heater.
operation.
only.
Do not use a
disconnect the regulator from the
6
spanner.
anti-clockwise.
water.
A stream of
assistance.
Screw
V.1
Publicidad
