Publicidad
Idiomas disponibles
Idiomas disponibles
Disassembly of the thermocouple or pilot is
necessary, please contact our after-sales service.
TECHNICAL ASSISTANCE BEFORE CALLING FOR FURTHER HELP
The heater doesn't light:
•
Check the gas cylinder to make sure that it is
•
Check the regulator to make sure that it is properly attached
and the cylinder valve is turned
•
Check that the instructions have been followed
lf this happens after the cylinder has been changed it would be
due to:
•
Air in the cylinder. Hold the control knob down for a longer
period of time until the pilot and main burner
the 3-HIGH
•
The cylinder may have been excessively
cylinder to reach room temperature before attempting to
start the
heater.
The heater turns off by itself:
•
lf the heater goes out on continuous working, repeat the
operation, following the instructions
•
lf it goes out soon after 30 minutes or so, it means that it is
operated in a badly ventilated area. Open a window or a
door to ventilate the area and
•
Avoid bumping the heater in
heater while in operation. The tip-over switch may be
activated and turn the heater off.
MAINTENANCE ANO CLEANING:
Before maintenance and cleaning, gas heater supply must
•
be turned off, the heater should be cold.
•
The heater should be checked annually by a qualified
technician for safe operation and in order to detect any
faults.
setting.
on.
faithfully.
reignite.
operation.
11
prohibited.
lf
full.
correctly.
light.
Switch to
cold.
Allow the
Don't move the
V.1
Publicidad
