Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTION FOR INSTALLATION:
•
Remove the appliance from its packaging.
•
Mount the different parts of the appliance according to
the illustrations in the appendix.
Assemble the individual panels with the supplied
•
•
Set the control knob to the (0) or OFF
•
Fit the gas hose with the appliance connection and tighten
with a clamp.
•
Use a regulator with a fixed setting of 28 to 30mbar and a
flow rate of 1000 to
•
Fit the other end of the special gas hose to the regulator
outlet and tighten with a
0.50 to 1.00
•
Fit the regulator on the gas cylinder (10kg) and tighten it
properly.
•
Open the cylinder valve and check the seal with soapy
Heater operation instruction:
The heater can be regulated to three different setting:1-LOW,2-
MEDIUM and
•
Open the valve on the heater cylinder 1 and 1/2
•
Press down the turn the control knob to 1-LOW position and
hold for 1O seconds.
•
While still pressing down the pilot light, press once or twice
on the ignition button until the pilot light (at the bottom of the
burner) ignites. Continue to hold the control knob down for
10- 15 seconds more. Release the button, and if the pilot flame
goes out, repeat the above operation.
1500g/h.
mtr.
3-HIGH.
lgnition mode: piezo
collar.
The hose must have a length of
8
screws.
position.
ignition.
turns.
water.
V.1
Publicidad
