Publicidad
Idiomas disponibles
Idiomas disponibles
Note: when lighting a new heater for the first time, it might be
necessary to hold the control knob down for longer time in order
to allow gas to flow to the pilot.
Once the heater in on at the 1-LOW setting, turning the control
knbo to 2-MEDIUM or 3-HIGH position will light the second and
third panel respectively.
To turn off the heater, turn back the control knob to the OFF
position and close the cylinder valve fully (clockwise). The heater
can only be turned off by closing the cylinder valve. lt cannot be
turned off by the control knob.
CHANGING THE CYLINDER:
Turn off the cylinder valve fully (clockwise) and allow the heater to
fully cool before removing and replacing the
attempt to remove the regulator while the heater is still
PLACE OF GAS HEATING:
•
This heater is designed to be placed on the floor and away from
the
walls.
direction of the center of the
materials from the vicinity if the
•
The appliance must be 0.5 meters away from the walls
•
The front of the unit must be clear of a minimum of 2 meters.
When using the heater, always point it in the
Min 500 mm
Min 1000 mm
room.
Clear all combustible
heater.
Min 500 mm
Min 1000 mm
9
cylinder.
Do not
running.
V.1
Publicidad
