Fagor PS-50/200 TP2 Manual De Instrucciones página 54

Grease all bearing blocks using high-temperature grease (2 shots of grease pump
per bearing block - 5 strokes for cylinder bearings on steam-heated machines)
Check the drive chain tension (large) and lightly grease the drive chain (large), the
pressure roller chain (small) and the sprockets with liquid grease
Visually check the condition of the ironing bands, the infeed bands, press fleece
and folder conveyor bands to anticipate their replacement if necessary
Check the tension of the ironing bands, infeed bands, presser fleece and folder
conveyor belts. This tension setting must be the same on both sides.
Visually check the condition of the support rollers (x4) and side rollers (x2) to
anticipate their replacement if necessary. (Except for steam-heated machines
Removal and cleaning of the GAS manifold (atmospheric and radiant) - gas
heating only
Replace the radiant burner filter (filter reference: 12235758)
Clean the exhaust ducts
Check and clean the GAS filters (GAS heating machine) or vapour filters (steam
heating machine) of the installation.
NOTE: The frequency is defined on the basis of a 40-hour working week, 2000 hours
corresponds to approximately one year.
Check and maintenance points
Frequency
(hours)
1000
2000
50