Sony SLS-1A Manual De Instrucciones página 29

Parts and Controls
Front
Illustrated below is the front of the speaker with the speaker grille removed.
 Speaker units
Rear
 AC inlet
 Power supply terminals for adjoining speakers
(DC IN/DC OUT)
Provided for power supply connection with the adjoining
speakers.
 DIP switch
Provided for changing the number of Dante input
channels (1 channel/8 channels) and/or making beam
control setup for 1-channel input.
: Set to the upper position
: Set to the lower position
 Analog input (INPUT) terminal
Provided for connecting an analog audio device using
the 3-pin Euro type terminal block header. At the time of
purchase, the analog input source is selected. You can
change the input source with the Line-Array Speaker
Manager application.


 
 
 Bass reflex vents
   
 Dante input and output terminals/indicators
(Dante IN/Dante OUT)
Provided for connecting a Dante compatible digital
device using an Ethernet cable.
Lit in green: Indicates that a network connection is
established.
Lit in orange: Indicates that a 1-Gbps or faster
communication is in progress.
 STATUS indicator
Lit (green): Indicates that the speaker is powered.
Lit (red): Indicates that the speaker is on standby.
Flashing (green):
Indicates that the recognition process is in progress.
Flashing (blue):
Indicates that an update is being applied to the
speaker.
Flashing (red):
The protection function of the speaker is active.
Unplug the power cord from the AC outlet, and then
plug it back in to turn on the power. If the speaker
remains in the same state after the power recycle,
contact your Sony dealer.
Flashing (sequence from green, blue, and to red):
Indicates that the speaker is being reset.
5
GB