Sony SLS-1A Manual De Instrucciones página 43

8
Confirm that wall mounting is complete.
Make sure of the following:
• None of the cables is twisted or pinched.
Warning
• Improper wiring of cables, including the power cord,
may cause a short circuit, resulting in an electrical
shock or a fire. For your safety, make sure that wall
mounting is complete.
Note
• Secure the speaker as illustrated below:
Horizontal installation
Vertical installation
• For horizontal installation, secure the speaker by
sliding it downward.
The speaker is not secured before it is slid down.
Make sure that the speaker is securely hooked over the
shoulder screws.
• For vertical installation, secure the speaker by sliding it
downward while pressing it against the wall.
The speaker is not secured before it is slid down.
Make sure that the speaker is securely hooked over the
shoulder screws.
Outer Painting
For outer painting of the speaker, it is recommended
to use acrylic lacquer paint.
Warning
Except for the purpose of outer painting, do not
attempt to disassemble or modify the speaker to
avoid the risk of electric shocks, fires, injuries, or
malfunctions.
Caution
While painting, be sure to allow adequate ventilation.
When removing and attaching the speaker grille, be
sure to avoid harming yourself.
Note
• While using a volatile solvent, watch out for fire to avoid
the risk of fires and accidents.
• Sony assumes no guarantee regarding the damage caused
by painting.
Painting the Speaker Grille
Remove the speaker grille from the speaker before
painting.
1
Remove the 4 screws securing the outer lid
to the right end of the speaker, and then
remove the lid.
2
Remove the 2 screws (  ) securing the
speaker grille.

19
GB