Bosch IR LD 1.0 CO2 Manual Del Operario página 35

en | 34 | IR LD 1.0 | Maintenance
!
Always use a locally compliant
5V DC charger with an output
of at least 1.0A.
50%
Fig. 20: Charging status icon (power
off)
7.3.4 Operation while charging
To operate the IR LD 1.0 while
charging:
1. Connect the charger, as in-
structed in section 7.3.3.
2. Power ON the IR LD 1.0.
 Active charging is indicated
with a lightning bolt icon in the
upper right corner of the screen
(see Fig. 21).
SP01502142 | 14.03.2022
A
Fig. 21: Steady state display with
charger connected
7.3.5 Battery temperature
warning
!
Immediately disconnect the
charging cable if the Battery
temperature warning screen is
displayed on the screen (see
Fig. 22).
!
Failure to disconnect the
charging cable to stop charging
when the Battery temperature
warning appears (see Fig. 22)
could result in fire, explosion,
and serious damage or injury.
!
If the Battery temperature
warning appears (see Fig. 22),
the IR LD 1.0. must remain
disconnected until both the
unit and the charger return to
ambient temperature. Allow
a minimum of three (3) hours
before attempting to reconnect
charger.
Bosch Automotive Service Solutions GmbH
50%
CO₂